Since 95% of the bicycles have been installed, the rest can be installed directly after receiving.
1. Adjust the top and left and right screws to rotate the adjustable riser 180 degrees and secure it in place.
2. Install handlebar riser
3. Take out the screws and nuts
4. After removing the screws, as shown in the figure
5. Install the front fork and tighten the screws and nuts
6. (1)Connect the motor wire (note that the arrows on both ends of the connector correspond)
(2)Install the motor wire holder
7. Install the fender bracket screws
8. Install lights
9. as the picture shows
10. As shown, the gasket is installed
11.Connect the light cable(note that the direction of the arrow needs to correspond) !!important
12. Take out the pedal with the letters “R” and “L”, align it with the crank hole and lock it with a wrench
The above content is explained in detail in the instruction manual that comes with the ebike. If you have any questions, please feel free to contact our customer service.
